ACCESSORIES
REPAIR KIT FOR RUBBER BOATS “RUBBER BOAT REPAIR SET“, yellow — E4400180 TREM
Each set containing differents sizes of néoprene fabric, one tube of special glue, accessories for repairing and sticking. - NEOPREN-HYPALON
Order request
REPAIR KIT FOR RUBBER BOATS “RUBBER BOAT REPAIR SET“, gray — E4700180 TREM
Each set containing differents sizes of néoprene fabric, one tube of special glue, accessories for repairing and sticking. - NEOPREN-HYPALON
In stock
REPAIR KIT FOR RUBBER BOATS “RUBBER BOAT REPAIR SET“, orange — E4300180 TREM
Each set containing differents sizes of néoprene fabric, one tube of special glue, accessories for repairing and sticking. - NEOPREN-HYPALON
Order request
BOAT COVER “COVY LINE“ MAXI TENDER — O2230360 TREM
- Waterproof fabric
- Anti-warmth aluminized fabric
- Made 100% in polyester 210D
- Equipped with fastening elastic or fastening lanyard
- Double sewing for longer life
- Polyester thickness 0,15 mm
- PA smeared
- UV resistant
In stock
POLYURETHANE GLUE PVC 250 ml — SOR74302
PREPARATION OF SURFACE
The surfaces must be clean, dry, and de-greased with MEK (in contact with MEK, PVC becomes scaly). Allow to dry.
APPLICATION
This adhesive is used with the hardener, at a rate of 4 % (or 40 ml per litre).
Mix 4 % of hardener with the desired amount of adhesive. Mix to get an even consistency.
Coat the two surfaces using a brush, applying an even film. Leave to dry for 5 to 10 minutes. When the adhesive begins to set, apply a second coat
of adhesive. Leave to dry for 10 minutes, then join and press firmly. Adhesion is immediate.
Full effectiveness is achieved after 48 hours. This process is carried out ideally at a temperature of 20°C and a relative humidity of less than 65%.
PACKING AND STORAGE
Packaging : 250 cc
Storage: 12 months in our original containers, hermetically sealed and between 5 and 25°C.
Cold, the viscosity increases until the formation of a solid gel in white glue revovers its properties after retun to 20°C.
In stock
